Does the Stop Movement node stop movement of a change position for good or it stops it temporary?
From my testing it seems to be only temporary.
How can I get it to Stop completely its movement regardless of how long it has been moving for?
EX: If the Power is off the gate should stop moving until the power is back.
My variables are setup properly, they work, they add and subtract when I go on the switches.
I have a simple Event that raises a gate at different speeds depending if a switch is active or not. My trouble is the Stop Movement node stops the gate for a time (likely the 5 second wait) but keeps going even if the variables / switch is Off.
I have a Stop Movement Node after each check to Stop the previous movement speed and allow the next one to begin, either slower or faster.
I really just need to interrupt the active / current Change Position until the switches add the variable back, however long the Event for my switches take to return power (Add the variable back) Then the gate checks again and continues moving according to the variable and speed.